Posting an owner's manual is really not needed. Upon successful completion of 80 percent or better,. The spark 1 Remove the seats. Excessive water in the bilge can splash into the engine, which can result in severe damage. . There's a lot that goes into owning a WaveRunner, but it should also be a rewarding experience.
Modifications to your watercraft may reduce safety and reliability, and render the water- craft unsafe or illegal for use. Always consult local boating au- thorities before riding your watercraft in unfamiliar waters. Do not attempt to replace the battery yourself. Save yourself Big money by doing your own repairs! Contact a Yamaha dealer or the U. If the fuel injection system needs to be adjusted, have a Yamaha dealer service the watercraft.
See page ter the engine compartment. Watercraft and Outboard marine engine 2001 exhaust emission standards. Do not jump wakes with another boat, which could result in se- or waves. The results are a smooth, high power output with low fuel consumption and low exhaust emissions. Make Do not use the reverse function to slow sure that there are no obstacles or people be- down or stop the watercraft as it could hind you before shifting into reverse. If any damage is found, have a to settle by waiting 5 minutes or more before Yamaha dealer repair the watercraft. Operation is subject to the following two conditions: 1 this device may not cause harmful interference, and 2 this device must accept any interference received, including in-.
See page 30 for rear seat lid. If you can open up an email then you can use this manual, its that simple! If you charge the battery Be sure to remove the battery from the. This 1052cc four cylinder, four-stroke Yamaha marine engine delivers more power in a lighter package than any other full-size, four-stroke normally-aspirated watercraft in the industry. Your WaveRunner requires periodic checks and lubrication to remain in efficient condition, so download a maintenance guide and keep track of all service intervals. Make sure that the rope is not looped around anything. I doubt that you can even find cheap aftermarket manuals for a 15 at this point, since they usually take 6-12 month to show up, but you can check on Ebay. Make sure that the stern drain plugs are Also, check that the battery leads are tight- tightened securely before launching the ened securely and that there is no corrosion watercraft.
Seats To remove the rear seat: Pull the rear seat latch up, and then pull the. Scan constantly for people, objects, and other watercraft. . Once the engine is idling, shift into reverse and gradually increase en- gine speed. Watercraft Education and Training The Online Boating Safety Course, available through the watercraft section of the yamaha- motor.
The en- 1 Stern eye gine can only be started in the unlock mode. When a passenger is boarding, both the pas- sengers and the operator should try to bal- ance the watercraft. You Can Fix It Today! The engine cannot be started if the security system is in the lock mode. Remove and inspect the spark plugs periodi- cally; heat and deposits will cause the spark plugs to slowly break down and erode. The reboarding step provides a handhold and In some conditions, however, the watercraft footstep for boarding the watercraft.
Owners manuals have always been free from Yamaha. See page 41 for more information. I don't recommend posting service manuals, since that could get you in trouble. Demand for them is pretty much nil, since they are pretty much available to anyone that owns a Yamaha ski through the Yamaha site. Do not attempt to modify this watercraft! See page 41 for Yamaha Security System lock and unlock mode selection pro- cedures. Have a Yamaha dealer replace the oil fil- Fuel tank for damage, cracks, and leakage.
The beeper sounds This display shows the ambient water temper- twice. Have a Yamaha dealer service the watercraft. Do not operate the engine at full throttle for at least 1 minute after the engine has been restarted. Both you and the meeting provided the other vessel gives you the right- vessel must alter course to avoid each other. Do not operate the watercraft in rough wa- ter, bad weather, or when visibility is poor; this may lead to an accident causing injury or death. See page 41 for Yamaha skier is being pulled to ride the watercraft at Security System lock and unlock mode selec- any time. See the accom- panying text in this chapter for details on how to perform the checks.
Consult a Yamaha dealer about any control or func- tion that you do not fully understand. The Cruiser seat is padded and molded to support the hips. Specific gravity for reference : 1. The tools provided in the tool kit are suf- ficient for this purpose, except that a torque wrench may also be necessary to tighten nuts and bolts. See page 30 for seat plug cap may be difficult to remove be- removal and installation procedures.